1/9/2024 0 Comments Ssd health testHowever, simple read/write tasks do not cause an extreme rise in temperature. Depending on SSD usage, you may face a temperature higher than the limit. SSD usually stays on between 30✬ to 65✬ or 86✯ to 149✯. In summary, if you are testing SSD, you only need to use the two software AS SSD Benchmark and CrystalDiskMark.Besides natural causes, here are some other reasons your SSD might be heating up It is suitable for mechanical hard drives, but the speed test can still be used as a reference, it will give a speed curve, you can see the stability of the ssd. Although these functions are also available in other software, it is commendable that this software integrates all these functions, and is very small and fast, but this tool is not easy to use for SSDs, and it is no longer suitable for the structure of SSDs. In addition, it can also detect the hard disk’s firmware version, serial number, capacity, cache, size, and the current Ultra DMA mode. Its main functions include hard disk transfer rate detection, health status detection, temperature detection, and disk surface scanning. It was originally used for ordinary hard disks. This is also a very old speed test software. It illustrates the impact of different file size ratios on disk speed. After completion, the data is expressed in the form of a histogram. The data package is read and written according to 0.5K, 1.0K, 2.0K and 8192KB. The software uses a test package of 64KB-256MB. ATTO Disk Benchmark is a disk/network performance test tool produced by ATTO. However, since it has not been updated for a long time, the accuracy of the speed test is not very good, so it is not very recommended. It was used to test USB flash drives in the past, and it can also be used for ssd tests. In addition to supporting general mechanical hard drives, it also supports SSD solid state drives and even some mobile hard drives, and the main function on the SSD is to test its interface type, firmware version and the number of times the SSD has been used. After starting it, you can visually check the entire health status, temperature and more related information of the hard disk. The focus is not on the speed test, but a practical ssd health diagnosis tool. The higher the value, the faster the read and write speed of small files, and the better the SSD.ĬrystalDiskInfo is abbreviated as CDI. In addition, it also uses the IOPS test results to indicate the number of read and write (I/O interface) operations performed by the solid state drive per second. It can test the smallest files at the same read and write speed. It is equivalent to replacing all the software mentioned above to detect SSDs. To check whether the driver status of SSD has been installed, it is currently the most worthy tool for testing SSDs. It can not only test the read and write speed of ssd, but also give the status check whether it has been 4K aligned or not. Compared with other testing softwares, this one is specially developed for ssd. This is our most recommended ssd testing software. It can not only test large files, but also read and write small files speed. It is a relatively accurate speed test software at present. It can test the speed of continuous read and write and random read and write of the hard disk, so that you can compare the performance of the hard disk. You can take it with you to test your device at any time. Its size is small, and the interface is relatively simple, easy to use, and easy to use. Of course, it is not a problem to test U disk and hard disk. It was prepared for ssd at the beginning. It is a speed test software that appeared earlier.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |